LCR-T7 Transistor Tester TFT Diode Triode Capacitance Meter Detector Multimeter NPN PNP MOSFET IR Multi-function Tester
Features:
1. Long Battery Life: Enjoy extended usage with the LCR-T7 transistor tester thanks to its built-in long-lasting lithium battery. No need to worry about frequent recharging during your testing sessions.
2. Accurate Testing: The LCR-T7 TFT diode triode capacitance meter is a versatile tool that can measure various components such as transistors, resistors, capacitors, inductors, thyristors, field-effect transistors, voltage regulators, dual diodes, and light-emitting diodes. Ensure accurate measurements for your electronic components.
3. Infrared Decoding: With the infrared decoding feature, simply point your remote control at the "IR" test hole on the tester and press a button. If successful, the capacitance LCR ESR meter displays the user code, data code, and corresponding infrared waveform. This allows you to easily verify and analyze the functionality of your remote control.
4. Automatic Calibration: The LCR-T7 multimeter transistor tester supports automatic calibration. By shorting the three test sockets and pressing the multifunction button, the tester will automatically initiate the calibration process. Simply follow the prompts and disconnect the shorting wire when instructed, without any additional steps required.
5. Auto Power Off: The LCR-T7 diode triode capacitor resistor test meter features an auto power-off function, ensuring power efficiency and prolonging battery life. When the tester is inactive for a certain period, it will automatically turn off, saving energy and preventing unnecessary battery drain.
Specification:
Origin: Mainland China
1. Can measure three tubes, two tubes, resistance, capacitance, inductance, thyristors, field effect tubes, voltage regulators, double two tubes, light-emitting two tubes, and so on.
2. Can measure the voltage
3. Built-in lithium battery, long battery life
4. Infrared decoding function
Aim the infrared remote control at the "IR" test hole of the tester and press the remote control button.
If the tester decodes successfully, it will display the user code and data code, and display the corresponding IR waveform.
If the tester fails to decode or can't decode, the user code and data code will not be displayed, at this time, if you are in the interface of the tester, you can't enter the interface of IR decoding, if you are in the interface of IR decoding, it still displays the decoding information of the last successful decoding, and the round dot in the upper right corner is used to indicate whether it receives the infrared data from the remote control, the red color indicates that the infrared data is being received, and the blue color indicates that the decoding is successful.
5. Automatic calibration
Short connect the three test stands, short press the multi-function button, the tester will be calibrated automatically.
Disconnect the short wires according to the prompts in the calibration process, no other operation is needed.
Note:
Charging please use external 5V power supply or cell phone USB power supply
The indicator light is red means charging, the indicator light is green means charging is complete.
Warm reminder: charging input voltage of 6V, please do not use over-voltage, otherwise it will damage the tester and the possibility of battery explosion!
Built-in lithium-ion battery, it is strictly prohibited to immerse the tester in water or near a heat source! For your personal safety, please strictly observe the specification and precautions for the use of lithium-ion batteries!
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-2cm measuring deviation due to manual measurement.