Available for various color TV memories (24 series IC), LCD (24.25 series IC), desktop motherboard (25 series IC) notebook (25 series IC) router (25 series IC) graphics card (25 series IC) DVD (25 series IC), the software of the set-top box (25 series IC) performs operations such as unlocking, backing up, erasing, burning, and verifying.
24 and 25 Series FLASH Programmer Description Overview:
Currently 24 and 25 series FLASH has become very popular. For the programming of these chips, only professional programmers can only support them, but professional programmers are very expensive, not for general maintenance users; therefore, we have produced an EEPROM and ST that can support 24 series. WINB IND, AMIC, MXIC, SST, SPANSION, EON, PMC and other manufacturers' 8-pin 25 series chip programmers.
The programmer features
1
It is made by special USB chip CH341A. USB1.1 communication. The programming speed is 2-3 times faster than the 25 series programmer made by ordinary ATMEGA8. The erase programming verification speed is approximately 2-3 Mbits per minute. Ideal for amateur programming 24 and 25 series FLASH.
2
support WIN98, WINME, WIN2K, WINXP, VISTA, WIN7-32 bit and other operating systems.
3
using USB port power supply, power supply output has 500mA fuse fuse (with fuse version), can effectively prevent external short circuit on the motherboard (to prevent burning the motherboard), the target board can also be powered with USB.
use
1: Plug the programmer into the USB port of the computer and open the programming software in "USB port 24-25 series programmer" or "new 32M+USB port 24-25 series programmer". Select the capacity of the chip. Write and erase chips.
Online download (USB to serial port, P/S end jump cap disconnected)
2 Plug the programmer into the USB port of the computer. The TX pin on the programmer is connected to the RX of the middle nine. The RX is connected to the TX of the middle nine, and the GND is connected to the GND of the middle nine.
Driver Installation
Select the corresponding COM port, open the download software of the corresponding platform, you can upgrade your machine online.
1: Install the parallel port driver (program the 24 and 25 series FLASH drivers) Put the P/S end cap on the PCB board
2: Install serial port driver (USB to serial port, mid-ninth and other serial port online download models for online download) Remove the P/S end cap on the PCB For detailed installation steps, see the instructions in the "CH341A Serial Driver and Installation Instructions - TB" folder. 24 series chip programming (P/S end jump cap closed) Plug the programmer into the USB port of the computer and open the programming software in "USB port 24-25 series programmer" or "new 32M+USB port 24-25 series programmer". Select the capacity of the chip and you can program . 25 series chip programming (P/S end jump cap closed)
Read 25X80 series 8M chip only 9 seconds. 25X80 erase- check empty - programming - check completion 4 steps only 1 minute 06 seconds